FairBidGuide

Insert or full-frame: which window replacement is your quote for?

Last updated November 18, 2026

This page may contain affiliate links. If you request quotes through them, we may earn a commission at no cost to you. How this works

A window can be replaced in two ways. An insert replacement puts a new window inside the old frame. A full-frame replacement takes the old frame out and starts from the bare opening. Full-frame costs more: Pella says it can add 20% to 30% to the project. A quote should say which method it covers. If it does not, ask before you compare it with another one.

The two methods side by side

Insert Full-frame
What comes out Sashes and hardware. The frame stays. The whole window, frame, and trim
Time per window About 1 hour 4 to 6 hours
Trim and siding Mostly left alone Interior and exterior trim removed, sometimes siding
Glass area Slightly smaller Same or larger
Hidden damage Stays hidden Found and repaired

Times are from Pella. The rest is from Marvin and This Old House.

What the difference costs

The extra money is mostly labor. The crew spends several more hours on each opening and then has to rebuild the trim.

Our window replacement cost calculator prices those extra hours at the wage level in your state. For a vinyl window, its typical full-frame price is about $180 to $320 higher per window than its typical insert price, depending on the state. That is an estimate. On ten windows it comes to roughly $1,800 to $3,200.

So two quotes for the same house can be thousands of dollars apart for an honest reason: they are for different jobs.

When an insert is enough

This Old House and Pella describe the same conditions:

When the whole frame should come out

Marvin lists soft spots, moisture damage, and peeling paint as signs that a frame may not be sound.

What an insert cannot fix

An insert covers the old frame. It does not repair it. This Old House notes that an insert cannot correct hidden frame damage, and Marvin warns that air leaks in the old frame may stay.

The glass also gets a little smaller, because the new window sits inside the old frame. On a large window you may not notice. On a small one you might.

Questions to ask

  1. Is this price for insert or full-frame replacement? Ask for the method to be written in the quote.
  2. Did you check each frame for rot and for square? A price given without looking at the frames is a guess.
  3. If a frame turns out to be damaged once the old window is out, what does it cost to switch that window to full-frame? Get a price per window in writing.
  4. For full-frame: are interior trim, exterior trim, and painting in the price?
  5. For insert: how much smaller will the glass be?
  6. Does this method need a permit here? Marvin notes that full-frame work is more likely to need one.

Check the numbers

Run your job through the calculator twice, once for each method. If your quote sits near the full-frame figure but describes an insert job, ask the contractor what explains the difference.

Method is one of several things a quote can leave unsaid. For the others, see 6 costs a window replacement quote often leaves out.

The figures here are approximate ranges for planning, not an offer or professional advice. Your price depends on your home, your location, and the contractor.

Check a contractor's quote in 10 minutes

A one-page checklist: what a complete quote contains, where the money should be visible, and what is usually left out.